Our products

Speedmaster complete 4" extension block assembly, includes pivot block unit for rudder attachment.

Speedmaster 5" extention block

UNAVAILABLE;FROM OCTURA®

One in stock balanced and polished. A 3 bladed version 1.85 dia. x 2.59" pitch. Ideal prop for .40/.45 engines running full surface or semi surface drives."

.150" Teflon tubing per foot. For use with OCTURA .150" (3.8mm) flexi cable only.

OCFHE5MM15S,
Coupling for connecting 5mm plain shaft to .150 Octura cable only.

Large engine mount rubber bobbins 20mm x 15mm with 6mm male and female ends. comes with S/steel nut, bolt & washers.

Large engine mount bobbins also used in rubber couplings. 20mm x 15mm, with 6mm studs and s/s nuts & lock washers.

Discontinued 20mm x 15mm Engine mount rubber bobbins with 5mm male and female ends, complete with s/s nut, washers and bolt.

A 14"  (360mm) flexi shaft using OCTURA .130" cable glued or silver soldered into a stainless steel 4mm stub shaft for fast electrics. Shafts can be made to your own requirement in cable and stub shaft length.
Standard shaft is 14"  (360mm) in length including 2.5" stub.
State shaft lengths when ordering if different from our standard length 

Aeromarine Auto bailer with filter screen

<strong>Aeromarine</strong> Non return self bailers with filter for expelling water from inside the hull while in motion. Self seals when the boat stops

CMB 19mm (3/4") Ultra high temperature exhaust coupler

CMB main bearing

MTronics Waterproof micro single channel failsafe for use with 4 and 5 cell receiver packs. Easy push button setup. Duel operation LED's. Low voltage sensing.

The mocom 5983 is the ideal prop for the Zenoah 26 or similar engines using conventional drive. (underhull) 59mm dia. x 83mm pitch

Silicon bronze prop ideal on 15cc Cats and surface drive monos.to

Waterproof radio box toggle switch with rubber toggle cap and seal. saves having to open your radio box to switch on.

Exhaust flange gasket

Spare 3.5mm x 22mm i.d. Orange silicone "O" rings to fit all of the the 22mm watercooled headers plus tuned pipes..

OUT OF STOCK
A right hand rotation prop.

3/16" Teflon tubing sold by the per inch,
To be used with 3/16" flexi shafts and cable. Fits K&S 9/32" brass tubing

OCTURA 5mm plain shaft motor coupling to connect to .150" cable. (Long body)

14" Flexi shaft .130" cable into 2.25" x 5mm stub shaft. Shafts can be made longer if required.

Futaba/ heavy duty wired switch harness with charge lead. 300mm

CMB 67 header retaining spring

CMB genuine small crankshaft bearing

SPECIAL OFFER Save £3.00 off NSP £25.95  Stainless steel prop for 15cc craft 

Speedmaster extention block, puts the rudder 6" from the transom.

Octura® BeCu drive dog prop 1.4 x 1.9 diam = 2.66" pitch. 3/16" bore