Our products

Threading of 1/8" bore drive dog propeller

Brass reducer to insert into 3/16" bore prop hub to go onto 4mm shaft.

The OCTURA® balancer consists of an extruded ali base incorporating two parallel steel rods for the prop balancing rod to roll on. There is a levelling screw in the base and three imperial size rods for the props. 1/8", 3/16" and 1/4", which are stored in the base body, plus instructions

The X6 series propellers have a slighly higher lift than the X4 & X5 series, and their pitch to diameter ratio is 1.6: 1. The blade profile is very much the same as the X4 series but is narrower and has a flatter cut off at the tip of the blade.

OUT OF STOCK AT OCTURA,.
The smallest of the X6 series with a 1/8 bore. Can be threaded 4mm."

 

 

 Good prop for 7.5cc surface drive monos and 3.5cc riggers. A higher lift prop than the X4 series with 1.6" pitch

OUT OF STOCK AT OCTURA The X646/3 prop is an ideal prop for use with a 7.5cc engine on most types of hull. the prop has slightly more lift than the X447/3 and 1.6:1 pitch as against the 1.4:1 of the X4 series.

 Good prop for 7.5cc surface drive mono & cats.

 

Largest of the right hand drive X6 series props.

 Largest of the X6 series, great prop for 26cc petrol engines Mnnos and 15cc riggers

Balance and polish 2 blade props 67mm and to 82mm.

Balancing & polishing 2 blade silicon bronze props from 40mm up to 82mm

Balance and Polish 3 blade props 35mm up to 50mm

OC4MM2187 Adapter 4mm to 3/16" shaft. Fits ont a 4mm shft to allow the use of props with a 3/16" bore