Our products

CMB 45 GPX  Tuned quiet pipe 

Aeromarine Picco 21 Titanium Conrod

Stainless Steel 15cc muffled tuned pipe for 22mm (7/8") inside header with water cooling & pressure feed. for CMB, Picco, OPS. etc.

Prather stainless steel strut with 3/16" needle bearings fitted. & mounting bracket. For setups 3.5cc to 15cc 

Prather  P255S Stainless steel prop. Dia. 2.4"  x Pitch 3.8"

NSP. £27.95

 Prather  P265S Stainless steel prop. Dia. 2.61"  x Pitch 4"

NSP. £28.95

 Aeromarine large shallow radio box with tape down lid. will take up to 4 standard servos.

Upgraded Radio box from previous version, VERY strong  plastic with bolt down lid, built in rubber seal, 2 bellows, all screws, nuts, screw in cap for radio switch or charging and servo tray for 2 standard size servos. The best radio box we have seen, with very strong main body.  Lid is 150mm x 150mm, body is 128mm x 128mm and 65mm deep including cover.

Fits between 5" rails,

Toothed starter belt 6mm wide x 17"  (450mm) reinforced with Kevlar for extra strength. Suitable for all size engines."

Starter belt 19" (490mm) x 6mm wide, reinforced wth Kevlar. No more black gunge in the boat.

SPDR-012-DU-5 Straight Back D/P Rudder Assy. Leading edge is %" from the transom

SPDR-013-10 6" x 1" Rudder straight blade with single water pick up

40-90 Rudder assembly. From transom to rudder leading edge 1 5/8". With integral single water pick up. Most suited to riggers and cats.

 Speedmaster rudder water nipples

 Speedmaster 3/16" FLARED flange brass bushing for 3/16" struts

 Speedmaster SPDSB-10-250F large flat bottom strut.

SPDSD2-G250 Gas - 1/4" Shaft 3 Bolt Transom Bracket Comes with 24" Square Drive Cable Has 4mm Titanium Adjustor Turnbuckle Length Approximately 6" to Prop Tips.

SPDSD3-G250 Gas - 1/4" Shaft Comes with 24" Square Drive Cable Has 5mm Titanium Adjustor Turnbuckle Length Approximately 6" to Prop Tips.

TFL SSS5694 Brushless motor 1200kv
Max. volts 41v
Revs. 38000
Shaft.  8mm

SSS5694 Brushless motor 800kv   7.3BHP up to 12S  
Max. volts 50v  max 5500watts
Revs. 38000
Shaft.  8mm

 Wire drive (.078") 2.5mm to 2.5" x  3/16" stub

 Wire drive silver soldered (.078")  2mm into 2.5" x 3/16" stub shaft  with 4mm thread.

Radio Active 52.5mm 4mm thread red nylon prop

The X6 series propellers have a slighly higher lift than the X4 & X5 series, and their pitch to diameter ratio is 1.6: 1. The blade profile is very much the same as the X4 series but is narrower and has a flatter cut off at the tip of the blade.

Y531 has 10% more pitch than the X431. Bore is 1/8" which can be opened to 4mm. or can be threaded 4mm. The material for this prop is remarkable strong

Y5 series prop which has 10% more pitch than X4 series. This drive dog prop has a 1/8" bore and can be threaded 4mm if required.

This prop has a 1/8" bore and can be threaded 4mm.  10% more pitch than the X435. Use when your running out of top end speed with your X435.