Our products

Right hand rotation (clockwise)

Hi-Energy flat Battery pack 4.8v, 2200mAh. Ni-MH, Retains 90% of its charge after 6 months

Main needle for servo operated valve

Standard Walbro 644 twin needle carb with priming bulb and without choke which gives a better intake of air.

Walboro 257 standard big bore carb.

 Good 26cc low power petrol engined Mono

Receiver battery pack. 6v 2000mAh  Ni-MH

 Hub bore is 1/4".  An ideal prop for use on the 26cc petrol engines.

Hi-Energy Rx. flat battery pack 6v, 1600mAh Ni-MH

One of the best three bladed props ideal for the large petrol engines such as the Zenoah G26, CMB 26 & 35RS, & Mathe 35cc. The prop has a 1/4 bore and 7/16" od. hub.

2.76" dia. x 3.864" pitch"

Carb barrel lever

Right hand rotation 70mm prop. Ideal prop for twin drive 26cc monos where contra rotating props are required.

5/8" ID. (16mm) x 4"  Blue heat resistant silicone exhaust coupler

Walbro carb diaphram fpr 257, 643, 644 carbs etc.

Walbro carb maintenance kit

 Suitable for high torque 26cc engines, and 35cc petol engines. Runs well on the CMB27cc petrol engine.

Stainless steel 3/16" x 2.5" stub shaft with 5mm thread. drilled to take either .130" or .150" flexi cable. State bore when ordering
Please state when ordering if a longer shafts is required.

6" Ultra high temperature,thick walled metal loaded silicone tube for exhaust silencing systems. Particularly suitable for helicopters, ducted fans and other high performance engine installations. Capable of withstanding an incredible 350°C!

3/4" ID. (19mm;x 4" long) Blue high temperature heat resistant silicone exhaust coupler. Silicone Tube is tough, extra flexible and heat resistant.

The largest of the X4 series props with 1/4 bore. 4.508" pitch. Use on 35cc + engines"

Octura 1/8" stainless steel stub shaft bored to take .098" cable

5mm Knurled aluminium finger nuts for securing radio box lids etc

6mm Knurled aluminium finger nut for securing radio box lids etc.

Fibre isolation block

Carb to fibre block gasket

Fibre block to crankcase paper gasket

Balance and polish 2 blade props 67mm and to 82mm.

OC64PKGPS OCTURA stainless steel prop shaft, 3/16" x 2.25" long, turned down to 1/8" for use with either .130" or .150 cable running in a 3/16" bearing strut, enabling a 1/8" bore prop to be used.